Advertisement
2
1397 Enhanced Field Supply Card
Installation
1397-5.24 March, 2005
ATTENTION: This drive and board contain ESD
!
(Electrostatic Discharge) sensitive parts and assemblies.
Static control precautions are required when installing,
testing, servicing or repairing the drive or board. Component
damage may result if ESD control precautions are not
followed. If you are not familiar with static control
procedures, reference AB publication 8000-4.5.2, "Guarding
Against Electrostatic Damage" or any other applicable ESD
protection handbook.
ATTENTION: Electric Shock can cause injury or death.
!
Remove all power before working on this product.
The drive is at line voltage when connected to incoming AC
power. Before proceeding with any installation or
troubleshooting activity, disconnect, lockout and tag all
incoming power to the drive. Verify with a voltmeter that no
voltage exists at terminals L1, L2 and L3 on the drive input
power terminal block.
❏ 1 Remove and lockout all incoming power to the drive.
❏ 2 For 1.5-30HP/230V drives
(2) captive thumb screws to remove the drive cover.
Captive
Thumb
Screw
1.5-30HP/230V and 3-60HP/460V Drives
with Drive Cover in Place
3-60HP/460V drives, loosen the
&
Captive
Thumb
Screw
Advertisement
