Status Messages - Novexx Solutions EIDOS XTO Series User Manual

Table of Contents

Advertisement

User Manual
XTO intermittent series
Set the code of the EIDOS ribbon used. The setting of the used ribbon code requires that some
specific parameters of the printer are automatically set in the optimal way for the ribbon in use (e.g.
Enhanced Mode, Accelerations, Jerk etc).
NOTE:
The thermal ribbon rolls must be purchased from the printer supplier, in order to
have the maximum guarantee of good operation. The use of non-certified ribbons
carries a high probability of malfunction with possible accelerated damage to the
thermal head or ribbon drag problems.

STATUS MESSAGES

General information about status reports
During operation, tests are continually carried out to determine whether a malfunction has
occurred. If a malfunction is detected, the corresponding status report appears on the display.
The list of messages, complete with their description, is shown in the document "RT578 - Error
messages and troubleshooting".
Warning messages
Warnings inform the operator about the occurrence of a certain event at the printer. The message
is displayed until it is unlocked by the user. If in READY status the printer continues operating
without intervention from the user. If the message appears in MANUAL mode, it must be unlocked
to go to READY mode and allow printing. The status report shown on the display is structured as
follows:
A
A
Alarm icon: press the key below the symbol to unblock the status message.
B
Warning number
C
Warning message
D
Background colour: yellow
E
Help icon: after pressing the icon, a quick troubleshooting guide appear.
F
Pause: it unlocks the message. The message will appear again when the operator comes back
to the main pages.
Edition C - 01/2024
B
C
Figure 80: Warning message
58
E
D
F
Operation

Advertisement

Table of Contents
loading

Table of Contents