Table of Contents
Advertisement
User Manual
XTO intermittent series
CLEANING ROLLS AND RIBBON PASSAGES
Check the status of rubber coated roll [R1]. Verify that the surface of the roll is smooth and even.
Check every single roll turn without jamming and is not crooked.
Note: It is very important to clean the rubber coated roll and to check sometimes that it rotates
freely, to avoid print overposition on the ribbon with bad print quality or missing parts in print.
How to operate
Use a jet of low-pressure air to clean the dust off the printing unit.
1.
Use a tissue or a paper tissue soaked in isopropyl alcohol to clean all the rolls and ribbon
2.
passages.
If necessary, lubricate the bushes with Ballistol oil.
3.
R1
Pay attention: do not dirty with oil the surface of rolls.
On no account use jets of water or steam to clean the printer.
Edition C - 01/2024
Figure 90: cleaning the printing plate
Figure 91: cleaning rolls
66
Preventive Maintenance
Advertisement
Table of Contents
