Mode Selection; Period Control (Perc); Delay Control (Delc); Width Control (Widc) - HP 8112A Operating, Programming And Servicing Manual

Mode Selection

Note
4-8 Operating
Depending on the control mode selected, the output signal may be
either Period, Delay, Width, or High Level controlled, by an external
voltage applied to the CTRL INPUT.
The control mode can be cycled through available options by pressing
the key below the mode indicators and the currently active mode
is shown by an LED indicator. Table 4-l indicates the permitted
combinations of control and operating modes.
Table 4-1. Operating/Control Mode Combinations
CTRL
PERC
DELC
DBLC
WIDC
HILC

Period Control (PERC)

Control input sensitivity is i-1.0 V to +lO.O V (t2.0 V to + 10 V in
the 20 ns to 100 ns range) and period ranges from 20 ns to 1 s are
available in eight non-overlapping decades. See Figure 4-5.
The decade is selected by setting PER within that decade, i.e.
PER=3 /.LS would mean than control input voltage cycling between
1 V and 10 V, will control the period between 1 ps and 10 /.Ls.
Whatever the value you select for PER, the upper limit for that
decade is displayed (10 ps if 3 /JS was selected as above). The vernier
keys are inoperative and the Range key is used to change range.

Delay Control (DELC)

Control input sensitivity is t1.0 V to i-10.0 V. Minimum delay is 75
ns and a maximum delay of 1 second is obtainable.
In DBL mode the time
input, when DELC is selected.
See Figure 4-5.

Width Control (WIDC)

Control input sensitivity is +l.O V to i-10.0 V and width range 10 ns
to 1 s in eight non-overlapping decades. See Figure 4-5.

High Level Control (HILC)

High Level control is available in the range -8.0 V to i-8.0 V. It is
important to note that while the Low Level (LOL) value can be
set to a maximum of j-7.95 V in 50 mV steps, the LIMIT facility
M O D E
NORM TRaIG GATE EWID EBUR
X
X
X X X
X X X
X X X
X X X
between
pulses will be varied by the control
X
X
X
X
X X