Equipment; Test Setup 1; Test Setup 2; Procedure - HP 8112A Operating, Programming And Servicing Manual

Max Jitter
0.2% of programmed value flOOps
Equipment w
n
n
n

Test Setup 1

Test Setup 2

Procedure

1. Set up the HP 8112A as follows:
2. Connect the HP 8112A and oscilloscope as shown in Figure 8-5.
3. Verify that for the following HP8112A WID settings the scope
4. Record your results on a copy of the Test Record, specified limits
Counter (HP 5335A)
Cable Assembly BNC (2
Digitizing Oscilloscope (HP 541211')
Attenuator 20 dB, 2 W. (2
50 RFeedthrough Termination
(Required if counter input impedance # 50 Q).
HP 8112A
Figure 8-5. Pulse Width Performance Test
Figure 8-6. Pulse Width Performance Test
Input Mode
Control Mode
Transition
DEL
HIL
display indicates that the HP 8112A output is within the specified
limits.
are given here and on the Test Record.
)
X
)
X
O s c i l l o s c o p e ( H P 5412xn
w i t h BNCISMA A d a p t o r
Counter (HP 5335A)
NORM
Off
Fixed
65 ns
1.00 v
- 1 . 0 0 v
Testing Performance 8-9