Troubleshooting (To Be Performed By Store Personnel) - Structural Concepts FUSION User Manual

TROUBLESHOOTING (TO BE PERFORMED BY STORE PERSONNEL)

CONDITION
Case Not Lining Up
Water Is On The Floor
Fan Emits Excessive Noise Call service provider.
Case Lights Are Not
Working
Case is Not Holding Prop-
er Temperature
See INSTALLATION: REMOVAL FROM SKID, REMOVING VERTICAL
LOWER FRONT PANELS section in manual for instructions on properly
aligning case (alongside other cases) and shimming rails.
Call service provider.
Check that Light switch is in the on position.
Check that ALL of the light cords and plugs are properly connected. See
START-UP: LIGHTS / OPERATION / LED REMOVAL & REPLACEMENT /
CORDS & PLUG / THERMOMETER section in this manual.
If case lights still do not come on, call service provider.
If a large amount of warm product was added to the case, it will take time
for the temperature to adjust. Product must be pre-chilled before placing in
case.
Check that the case is not in the sun or near a heat or air-conditioning vent.
See OVERVIEW / TECHNICAL INFORMATION / WARNINGS section in
this manual for specifics.
If case is located near outside doors, temperature fluctuation can hinder
unit's ability to maintain temperature.
Check air return grilles (area at front of decking) for obstructions. DO NOT
set product on air grilles as this will prevent proper airflow!
If case still is not holding proper temperature, call service provider.
19
TROUBLESHOOTING