Cutting Unit Maintenance; Blade Safety; Installing The Cutting Unit (Models 04835 And 04845) - Toro Greensmaster e1021 Operator's Manual

nut (Figure 35). Repeat step
the tension if necessary.
Figure 35
1. Front-cable jam nut
2. Rear jam nut
2 and adjust
g343382
3. Brake cable

Cutting Unit Maintenance

Blade Safety

•
Use care when checking the reel cutting-unit.
Wear gloves and use caution when servicing the
reel.
•
A worn or damaged blade or bedknife can break,
and a piece could be thrown toward you or
bystanders, resulting in serious personal injury or
death.
•
Inspect the blades and bedknives periodically for
excessive wear or damage.
•
Use care when checking the blades. Wear gloves
and use caution when servicing them. Only
replace or backlap the blades and bedknives;
never straighten or weld them.
•
When servicing the blades, be aware that you
can still move the blades after you disconnect the
power.
Installing the Cutting Unit
(Models 04835 and 04845)
1. Move the kickstand to the C
position.
2. Remove the hardware that secures the reel-drive
assembly to the side plate
1. Socket-head screw
2. Spacer
3. Washer
3. Remove the reel-drive assembly, flat washers,
spring washers, and spacers from the side plate
(Figure 36).
4. Align the cutting unit to the frame.
5. Use 4 socket-head screws to secure the cutting
unit to the frame
35
-U
UTTING NIT
(Figure 36).
Figure 36
4. Spring washer
5. Nut
(Figure 37).
-S
ERVICE
g333187