Removing The Transport Wheels; During Operation; During Operation Safety - Toro Greensmaster e1021 Operator's Manual

2. Ensure that the traction and reel-drive controls
are in the N
EUTRAL
3. Start the machine; refer to
(page 21).
4. Set the speed control to S
the machine up, gradually engage the traction
drive, and slowly increase the machine speed.
5. Adjust the speed control to operate the mower
at the desired ground speed and transport the
machine to the desired destination.
Transporting the Machine Using a
Trailer
Use a trailer to transport the machine a considerable
distance. Use caution while loading and unloading the
machine onto the trailer.
1. Carefully drive the machine onto the trailer.
2. Shut off the machine and engage the parking
brake.
3. Use a full-width ramp for loading the machine
into a trailer or truck.
4. Securely fasten the machine to the trailer.
Note:
You can use the Toro Trans Pro trailer to
transport the machine. For instructions on loading the
trailer, refer to your trailer Operator's Manual.
Removing the Transport
Wheels
1. Release the clutch bail, use the speed control
to lower the machine speed, and shut off the
machine.
2. Move the kickstand to the
T -W
RANSPORT HEEL
Kickstand (page
3. Remove the transport wheels by pushing the
wheel-locking clips out of the axles
position.
Starting the Machine
, tip the front of
LOW
-S position; refer to
ERVICE
16).
(Figure
1. Axle
4. Carefully lower the machine off of the kickstand
by pushing forward slowly or by lifting the lower
handle support, allowing the kickstand to spring
back to the S
(page 16).

During Operation

During Operation Safety

General Safety
•
The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Wear appropriate clothing, including eye
protection; long pants; substantial, slip-resistant
footwear; and hearing protection. Tie back long
22). hair and do not wear loose clothing or loose
jewelry.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Before you turn on the machine, ensure that all
drives are in neutral, the parking brake is engaged,
and you are in the operating position.
•
Keep bystanders and children out of the operating
area. If co-workers must be present, use caution
20
Figure 22
2. Wheel-locking clip
position; refer to
TORAGE
g274946
Kickstand