Toro Greensmaster e1021 Operator's Manual page 29

DANGER
Contact with water while operating the
machine could cause electric shock, causing
injury or death.
Do not handle the plug or the charger with wet
hands or while standing in water.
Important:
Check the power supply cord
periodically for holes or cracks in the insulation.
Do not use a damaged cord. Do not run the cord
through standing water or wet grass.
1. Insert the charger plug on the power supply cord
into the matching input power socket on the
charger.
WARNING
A damaged charger cord can cause an
electrical shock or a fire.
Thoroughly inspect the power supply
cord before using the charger. If the cord
is damaged, do not operate the charger
until you obtain a replacement.
2. Insert the wall plug end of the power supply cord
into a grounded electrical outlet.
Charging the Battery Pack
Recommended charging range: 0° to 45°C (32° to
113°F)
Note:
The battery shuts down and does not charge
at temperatures below 0°C (32°F) and above 50°C
(122°F).
1. Park the machine in the location designated for
overnight charging.
2. Engage the parking brake.
3. Shut off the machine and remove the key.
4. Disconnect the T-handle connector from the
main wire harness to the main-power-supply
connector on the battery base
1. T-handle connector
Monitoring the Charging Process
and Troubleshooting
Note:
during the course of charging. Most are routine.
If there is a fault, the error indicator light will flash
amber, or light solid red. An error message will appear
in the LCD display
with the letter E or F (for example, E-0-1-1).
To correct an error, refer to the machine Service
Manual. If none of these solutions correct the issue,
contact an authorized Toro distributor.
(Figure 29).
Disconnecting the Charger
29
Figure 29
5. Clean and dry both the battery pack and charger
connectors.
Important:
Do not use strong solvents that
will degrade the strength of the connector
plastic. Do not use dielectric grease on the
connector or battery contacts.
6. Align the positive connectors (marked with a
"+") of the charger connector and the power
supply connector and push them together until
they lock.
The LCD status display displays messages
(Figure
1. Disconnect the charger T-handle connector from
the main battery power supply connector affixed
to the battery tray.
Important:
Do not pull on the cables
2. Place the charger T-handle and cord in a storage
position that will avoid damage.
2. Main-power-supply
connector
28) 1 digit at a time, starting
g340841