Shutting Off The Machine; After Operation; After Operation Safety - Toro Greensmaster e1021 Operator's Manual

Shutting Off the Machine

1. Release the clutch bail.
2. Move the speed control to the S
3. Move the key switch to the O
remove the key.

After Operation

After Operation Safety

General Safety
•
Park the machine on a level surface, engage the
parking brake, shut off the machine, remove the
key (if equipped), and wait for all movement to stop
before you leave the operator's position. Allow
the machine to cool before adjusting, servicing,
cleaning, or storing it.
•
Clean grass and debris from the machine to help
prevent fires.
•
Allow the machine to cool before storing the
machine in any enclosure.
•
Do not store the machine where there is an open
flame, spark, or pilot light, such as on a water
heater or on other appliances.
Battery and Charger Safety
General
•
Improperly using or maintaining the battery
charger could result in injury. To reduce this
potential, comply with the all safety instructions.
•
Use only the supplied charger for battery charging.
•
Confirm the voltage that is available in your
country before using the charger.
•
For connection to a supply not in the US,
use an attachment plug adapter of the proper
configuration for the power outlet, if needed.
•
Do not get the charger wet; keep it protected from
rain and snow.
•
A risk of fire, electric shock, or injury may result
from using an accessory not recommended or
sold by Toro.
•
To reduce risk of a battery explosion, follow these
instructions and the instructions for any equipment
that you intend to use near the charger.
•
Batteries could emit explosive gasses if they are
significantly overcharged.
Training
•
Never allow children or untrained people to
operate or service the charger. Local regulations
position.
LOW
position and
FF
Preparation
Operation
25
may restrict the age of the operator. The owner
is responsible for training all operators and
mechanics.
•
Read, understand, and follow all instructions on
the charger and in the manual before operating
the charger. Be familiar with the proper use of the
charger.
•
Keep bystanders and children away while
charging.
•
Wear appropriate clothing while charging,
including eye protection; long pants; and
substantial, slip-resistant footwear.
•
Shut off the machine and wait 5 seconds until the
machine has completely powered down before
charging. Failure to do this may cause arcing.
•
Ensure that the area is well ventilated while
charging.
•
Read and follow all precautions for charging.
•
The charger is for use only on nominal 120 and
240 VAC circuits, and is equipped with a grounding
plug for 120 VAC operation. For use with 240 V
circuits, contact your authorized Toro distributor for
the correct power cord.
•
Do not charge a frozen battery.
•
Do not abuse the cord. Do not carry the charger
by the cord or yank on the power supply cord to
disconnect the charger from the receptacle. Keep
the cord from heat, oil, and sharp edges.
•
Connect the charger directly to a grounding
receptacle. Do not use the charger on an
ungrounded outlet, even with an adaptor.
•
Do not alter the provided power cord or plug.
•
Avoid dropping a metal tool near or onto a battery;
it might cause a spark or short-circuit an electrical
part that could lead to an explosion.
•
Remove metal items such as rings, bracelets,
necklaces, and watches when working with a
lithium-ion battery. A lithium-ion battery can
produce enough current to cause a severe burn.
•
Never operate the charger without good visibility
or light.
•
Use an appropriate extension cord.
•
If the power supply cord is damaged while it
is plugged in, disconnect the cord from the
wall receptacle and contact an authorized Toro
distributor for a replacement.
•
Unplug the charger from the electrical outlet when
not in use, before moving it to another location, or
prior to servicing it.