Adjusting The Latch Bolt For The Handle-Height Adjuster - Toro Greensmaster e1021 Operator's Manual

4
Adjusting the Latch Bolt for
the Handle-Height Adjuster
No Parts Required
Procedure
If the handle-height adjuster is not parallel with the
upper receiver weldment, perform the following steps
to adjust the bolt:
1. Loosen the nut on the latch bolt so that the bolt
head can move freely just beyond the pivot stop
(Figure 13).
Note:
You can apply pressure to the
handle-height-adjuster spring to reduce tension
on the bolt.
Figure 13
1. Nut
2. Pivot stop
2. Rotate the bolt clockwise or counter-clockwise
to adjust the angle of the handle-height adjuster
in or out. The handle-height adjuster should
be parallel to the upper receiver weldment as
shown in Figure
3. Latch bolt
14.
1. Upper receiver weldment
2. Handle-height adjuster
3. Tighten the nut on the latch bolt
that the new bolt position is secured against the
pivot stop.
g440364
12
Figure 14
3. Bolt—clockwise
orientation
4. Bolt—counter-clockwise
orientation
(Figure
g439288
13) so