Table of Contents
Advertisement
HercuLink
Communication
Communication
Be sure to set up Communications before operating the actuator with the PDA. Settings must match those
of the actuator. Once settings match you can change them.
Prompt
Target Address
Baud Rate
Query
Query Result
Type:
Name:
4
Selections or
Range of Setting
1-99
Address of the actuator
2400
Baud rate of the actuator
4800
9600
19200
After selecting Target Address and Baud Rate, select Query
to verify communications are functioning. Result of query is
shown under Query Result.
If the query fails, the result will say "No Response" indicating
the PDA is not communicating with the actuator. Check for
matching address and baud rate between the PDA and
actuator.
If the query succeeds, the result will show:
Device type (e.g. SA2001)
Software version (e.g. 1.0)
Tag Name of the device (e.g. SA2000)
You are now ready to operate the actuator with the PDA.
HercuLink™ - User Manual
Parameter Definition
Release 3
8/02
Advertisement
Table of Contents
