Engine Air Cleaner Element - Replace - Perkins 4008-30 Operation And Maintenance Manual

SEBU9077-02
NOTICE
Failure to protect some engine components from
washing may make your engine warranty invalid. Al-
low the engine to cool for 1 hour before washing the
engine.
Periodic cleaning of the engine is recommended. A
clean engine provides the following benefits:
• Easy detection of fluid leaks
• Maximum heat transfer characteristics
• Ease of maintenance
Note: Caution must be used to prevent electrical
components from being damaged by excessive water
when the engine is cleaned. Pressure washers and
steam cleaners should not be directed at any
electrical connectors or the junction of cables into the
rear of the connectors. Avoid electrical components
such as the alternator, the starting motors, and the
ECU.
Ensure that care is taken that the safety labels,
emission label, and any information labels are not
removed during engine cleaning.
Engine Air Cleaner Element -
Replace
NOTICE
Never run the engine without an air cleaner element
installed. Never run the engine with a damaged air
cleaner element. Do not use air cleaner elements
with damaged pleats, gaskets or seals. Dirt entering
the engine causes premature wear and damage to
engine components. Air cleaner elements help to pre-
vent airborne debris from entering the air inlet.
NOTICE
Never service the air cleaner element with the engine
running since this will allow dirt to enter the engine.
Renew the air filter elements if the service indicators
are triggered. Refer to Operation and Maintenance
Manual, "Engine Air cleaner Service Indicator -
Inspect" for more information.
Some engines are equipped with air intake
precleaners. Clean the precleaners before
maintenance is performed on the air filters. Ensure
that dirt does not enter the housing of the air cleaner.
4008-30 Air Cleaner
Illustration 56
4008-30
1. Isolate the electrical supply to the engine.
i06683217
2. Release the clips (3) and remove end cover (4).
3. Remove the old element (2) from the housing (1).
Discard the old element.
Note: Ensure that dirt does not enter the housing.
4. Install a new element (2) into the housing (1). Align
the end cover (3) to the housing (1). Secure the
clips (3). Ensure that both filter elements are
replaced at the same time.
Maintenance Section

Engine Air Cleaner Element - Replace

73
g02041313