Table of Contents
Advertisement
M0108133-04
Engine - Clean
Personal injury or death can result from high
voltage.
Moisture
can
create
conductivity.
Make sure that the electrical system is OFF. Lock
out the starting controls and tag the controls " " DO
NOT OPERATE" " .
NOTICE
Accumulated grease and oil on an engine is a fire
hazard. Keep the engine clean. Remove debris and
fluid spills whenever a significant quantity accumu-
lates on the engine.
Periodic cleaning of the engine is recommended.
Steam cleaning the engine will remove accumulated
oil and grease. A clean engine provides the following
benefits:
• Easy detection of fluid leaks
• Maximum heat transfer characteristics
• Ease of maintenance
Note: Caution must be used to prevent electrical
components from being damaged by excessive water
when the engine is cleaned. Pressure washers and
steam cleaners should not be directed at any
electrical connectors or the junction of cables into the
rear of the connectors. Avoid electrical components
such as the alternator, the starter, and the ECM.
Protect the fuel injection pump from fluids to wash the
engine.
Ensure that care is taken that the safety labels,
emission label, and all other information labels are
not removed during engine cleaning.
i07926240
paths
of
electrical
Engine Air Cleaner Element -
Replace
NOTICE
Never run the engine without an air cleaner element
installed. Never run the engine with a damaged air
cleaner element. Do not use air cleaner elements
with damaged pleats, gaskets or seals. Dirt entering
the engine causes premature wear and damage to
engine components. Air cleaner elements help to pre-
vent airborne debris from entering the air inlet.
NOTICE
Never service the air cleaner element with the engine
running since this will allow dirt to enter the engine.
Servicing the Air Cleaner Elements
Note: The air filter system may not have been
provided by Perkins. The procedure that follows, is
for a typical air filter system. Refer to the OEM
information for the correct procedure.
If the air cleaner element becomes plugged, the air
can split the material of the air cleaner element.
Unfiltered air will drastically accelerate internal
engine wear. Refer to the OEM information for the
correct air cleaner elements for your application.
• Check the pre-cleaner (if equipped) and the dust
bowl daily for accumulation of dirt and debris.
Remove any dirt and debris, as needed.
• Operating in dirty conditions may require more
frequent service of the air cleaner element.
• The air cleaner element should be replaced at
least one time per year.
Replace the dirty air cleaner elements with clean air
cleaner elements. Before installation, the new air
cleaner elements should be thoroughly checked for
tears and/or holes in the filter material. Inspect the
gasket or the seal of the air cleaner element for
damage. Maintain a supply of suitable air cleaner
elements for replacement purposes.
Air Cleaners
Some application can have dual elements. The dual
air cleaner contains a primary air cleaner element
and a secondary air cleaner element. Both element
must be replaced at the same time.
Do not replace the air cleaner filter elements in a dirty
environment, as dirt can enter the air system when
the elements are removed.
85
Maintenance Section
Engine - Clean
i08154921
Advertisement
Chapters
Table of Contents
