Tools and Parts—All Models
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Phillips screwdriver
Scissors
Level
Parts supplied
Check that all parts are included in parts package.
A
B
C
D
H
I
A. Foam seal with adhesive
E. " screws (4) (6300 and 8k models only)
strip
F.
B. Foam seal without
adhesive strip
G. Side curtains (2)
C. Window lock bracket
H. Top channel seal (on some models)
D. Side bracket (on some
models)
Location Requirements—All Models
IMPORTANT: Observe all governing codes and ordinances.
Check the location where the air conditioner will be installed.
Make sure you have everything necessary for correct installation.
The location should provide:
Grounded electrical outlet within 6 ft (183 cm) of where the
power cord exits the air conditioner.
NOTE: Do not use an extension cord.
Free movement of air in room to be cooled.
A large enough opening for the air conditioner. Installation
parts are supplied for double-hung windows.
Adequate wall support for weight of air conditioner. Air
conditioner weighs 50 lbs to 75 lbs (22.7 kg to 34 kg).
4
INSTALLATION REQUIREMENTS
Tape measure
Cordless drill and
Pencil
G
E F
" screws (5) (6 provided on 10k and 12k
models)
I. Top channel (on some models)
NOTE: Cabinet louvers must not be obstructed. Air must be able
to pass freely through the cabinet louvers.
" bit
Window installation
Window Opening Measurements—Small Chassis:
6300 Btu and 8000 Btu:
21" (53.3 cm) minimum to 33 " (85 cm) maximum opening
width.
13 " (34.3 cm) minimum opening height
Window Opening Measurements—Large Chassis: 10k and
12k Btu
24" (61 cm) minimum to 36" (91.4 cm) maximum opening
width.
15" (38.1 cm) minimum opening height.
A. Small chassis: 21" (53.3 cm) minimum;
B. Small chassis: 13 " (34.3 cm) minimum;
A. Cabinet louvers
A
B
Large chassis: 24" (61 cm) minimum
Large chassis: 15" (38.1 cm) minimum
A