Advertisement
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 1A. Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
A.
Connect Right Rear Support (C) and Left Rear Support (B) to Main Frame
Assembly (A) and secure using:
Two 3 (M10x100 Hex Head Bolt)
Four 5 (M10 Arc Washer)
Two 7 (M10 Nylon Lock Nut)
B.
Insert 40X80mm End Cap (1) into Main Frame Assembly (A).
4
Advertisement
