Lanner NCA-4210 User Manual page 28

NCA-4210 User Manual
The system supports 1x 3.5" or 2x 2.5" SATA HDDs or SSDs as data storage. Please follow the steps below
for installation. (Note: the following steps are based on 2x 2.5" SATA disk drives installation).
1. Locate the disk drive tray at the corner of the
system.
2. Slide the tray downwards. Then the tray will
be loosened from the two latching spots.
3. Take the tray out and prepare to install a
SATA 2.5" disk drive.
4. Place the disk drive as shown in the image
below. Apply two (2) screws for each side of
the disk drive.
28
SATA connectors
on this side