Watchguard Firebox X1000 Reference Manual page 88

Vpn gateway
Hide thumbs Also See for Firebox X1000:
Table of Contents

Advertisement

CHAPTER 5: Common Log Messages
76
ipseccfg[] No remote gateway associated with xxx
Indicates that the ipseccfg was unable to parse a preconfigured
remote gateway from the configuration file, possibly due to a
corrupted configuration file. Try reconfiguring your VPN tunnel
options and/or Mobile User IPSec options.
ipseccfg[]: No Remote Gateways configured, aborting ipseccfg
Indicates there are no IPSec tunnels configured on the Firebox.
ipseccfg[] Unable to verify inbound remote user policy(12),
aborting ipsec config
If this error appears, your configuration file might be corrupted.
Try reconfiguring your VPN tunnel options and/or your mobile
user IPSec tunnel options.
ipseccfg[] Will proxyarp for x.x.x.x on ethx
ipseccfg is the process responsible for managing IPSec tunnels.
This message indicates that the ipseccfg determined that it needs
to proxy-ARP for this IP address. This usually occurs for Mobile
User VPN IP addresses.
kernel: eth2: Setting full-duplex based on MII#31 link
partner capability of 45e1
Indicates that the Firebox determined it can set the Ethernet
interface to full-duplex. Earlier Fireboxes had software-type link
negotiation. Later transceivers did this automatically in hardware.
This message should be seen only on older Fireboxes.
kernel GRE: short packet: 30984\\12)
A GRE packet was corrupted on its way to the Firebox. In other
words, the length in the packet was changed and reported an
incorrect number of bytes.
kernel MASQ failed tcp/udp checksum from 205.181.115.231
Usually indicates packet corruption. A checksum is a count of the
number of bits in a transmission unit. This number is included
with the unit so that the receiver can check to see whether the
specified number of bits arrived. If the counts match, the receiver
assumes that it received a complete transmission.
kernel Memory use at 90 percent, low memory condition in
effect
Indicates that fwcheck will activate because the Firebox passed its
predefined low memory threshold.
WatchGuard Firebox System

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents