Dynamic Nat Dialog Box - Watchguard Firebox X1000 Reference Manual

Dynamic NAT dialog box

Reference Guide
Enable Dynamic NAT
Select to enable dynamic NAT.
TCP Idle Timeouts
Enter the time in seconds for TCP idle timeouts. For more
information on TCP, see chapter 1 of the Reference Guide.
Arrows
Use the arrows to select your preferred value.
TCP Finish Timeout
Enter the TCP finish timeout in seconds. For more information on
TCP, see Chapter 1 of the Reference Guide.
Arrows
Use the arrows to select your preferred value.
UDP Finish Timeout
Enter the UDP finish timeout in seconds. For more informationa
on UDP, see chapter 1 of the Reference Guide.
Arrows
Use the arrows to select your preferred value.
Use Dynamic NAT on these networks
Enter the UDP finish timeout in seconds. For more informationa
on UDP, see chapter 1 of the Reference Guide.
Add
Enter, in the box, the IP address of the network to which you want
to add dynamic NAT and click Add.
Remove
Click to remove a network from the list above.
OK
Closes this dialog box and saves any changes.
Cancel
Closes this dialog box without saving any changes.
Help
Click to access the online Help system.
Policy Manager
185