SANY SCM2000C-8S Safety, Operation & Maintenance Manual/Parts List page 27

SCM2000C-8S Milling Machine Safety
2.Safety
2.1 General
2.1.1 Introduction
This Safety, Operation and Maintenance Man-
ual is a guide for you to operate your equip-
ment properly.
It contains technical and safety information
necessary for operation of your equipment.
Read and understand each section of the
manual.
Always operate your equipment according to
national, provincial, prefectural and municipal
laws and regulations. The safety information
for operation in this manual are just
suggestive.
Sany cannot anticipate every possible circum-
stance that might involve a potential hazard
during operation and maintenance. The
Safety messages in this manual and on the
product are, therefore, not all inclusive. If a
procedure, work method or operating techni-
que that is not specifically recommended in
this manual is used, you must be sure that it is
safe for you and for others. You should also
ensure that the product will not be damaged
or be made unsafe by the operation, lubrica-
tion, maintenance or repair procedures that
you choose.
The information, specifications, and illustra-
tions in this publication are on the basis of in-
formation that was available at the time that
the publication was written. Sany reserves the
right to change these information at any time
without prior notice. Consult Sany dealer to
obtain the latest information or if you have any
question on the information provided in this
manual.
Safety, Operation and Maintenance Manual-April 2020 2-5