Refuelling - Fayat Group BOMAG BM 500/15 Service Manual

General – Concerning your safety
Milling application with levelling
system
1.2.7.6 Parking the machine

1.2.8 Refuelling

28
Never reach into the running conveyor system (e.g. for the purpose
of cleaning).
Never swing the loading conveyor belt over persons or the truck
cabin.
During milling applications with levelling system components and
assemblies of the machine are moved manually or automatically.
Moving components and assemblies of the machine can cause
severe injuries and material damage.
Make sure that there are no persons in the danger zone.
Never work on the sensors while the levelling system is active.
Make sure that the machine is operated, controlled and monitored
by a qualified and experienced operator.
Run the conveyor belt empty.
Do not park the machine in front of stairs or ladders, water
hydrants etc., if this would obstruct their use.
Park the machine on horizontal, level, firm ground.
Before leaving the machine:
n
shift all control levers to "Neutral position", "Off" or "0",
n
apply the parking brake,
n
shut down the engine, pull off the ignition key,
n
pull off the main battery switch,
n
secure the machine against unintended use.
Do not jump off the machine, but use hand grips and access steps.
Mark machines, which could be in the way, with a clearly visible
sign.
When parking on ascents or descents use appropriate means to
secure the machine against rolling.
Do not inhale any fuel fumes.
Refuel only with the engine shut down.
Do not refuel in closed rooms.
No open fire, do not smoke.
Static charges may be generated in the fuel as it passes through
the filling system. The discharge of these charges in the presence
of combustible vapours can cause fire or an explosion.
Ultra-low sulphur diesel fuel poses a higher risk of combustion
caused by the static charging than diesel fuel with a higher sulphur
content.
BM 500/15