Refuelling - Fayat Group BOMAG BW 28 RH Service Manual

1.2.7.4 Cross slope
Fig. 7
1.2.7.5 Parking the machine

1.2.8 Refuelling

General – Concerning your safety
The tipping angle was measured statically on level, hard ground
with the machine stopped and without steering.
The max. permissible cross slope of the machine may be limited by
the max. permissible slanted position of the engine.
The specified angle must not be exceeded.
With loose soil, acceleration/deceleration, steering operated or
attached accessories, the tipping angle may be considerably lower.
Driving across slopes should therefore be strictly avoided, because
of the high risk of tipping over and the related risk of severe or
even fatal accidents.
Park the machine on horizontal, level, firm ground.
Before leaving the machine:
n
shift all control levers to "Neutral position", "Off" or "0",
n
apply the parking brake,
n
shut down the engine, pull off the ignition key,
n
pull off the main battery switch,
n
secure the machine against unauthorized use.
Do not jump off the machine, but use hand grips and access steps.
Mark machines, which could be in the way, with a clearly visible
sign.
When parking on ascents or descents use appropriate means to
secure the machine against rolling.
Do not inhale any fuel fumes.
Refuel only with the engine shut down.
Do not refuel in closed rooms.
No open fire, do not smoke.
Static charges may be generated in the fuel as it passes through
the filling system. The discharge of these charges in the presence
of combustible vapours can cause fire or an explosion.
Ultra-low sulphur diesel fuel poses a higher risk of combustion
caused by the static charging than diesel fuel with a higher sulphur
content.
You should therefore always make sure that the filling system is
properly grounded and that there is equipotential bonding to the
machine. If necessary use a connecting cable between filling
system and vehicle ground.
Monitor the entire refuelling process.
BW 28 RH 27