Cold Jet i3 MICROCLEAN 2 Operator's Manual page 21

1. Position the machine
close to the surface
being cleaned.
2. Push down on the
locking mechanism of
the cabinet's front and
back wheels to prevent
the cabinet from moving.
3. Attach the blast hose
and control cable to the
machine.
4. Attach an applicator to the blast hose and control cable.
5. Attach a nozzle to the applicator.
6. Connect the static ground wire clip to the blasting surface.
7. Attach the power cord to the machine and then to a properly grounded electrical outlet. The
machine will go into a calibration mode which will take 15-20 seconds.
Click to go to Top of Document
Machine Setup
21 2023-08-29