Machine Setup - Cold Jet i3 MICROCLEAN 2 Operator's Manual

WARNING
To store the machine, go to the

Machine Setup

WARNING
WARNING
CAUTION
CAUTION
Click to go to Top of Document
Do not lift the machine using the lid handlebar or the rear cable holder
as there will be no stability which could cause damage to equipment or
harm to personnel.
Shutting Down the Machine
Improper installation of the machine or the applicator could cause injury
to the operator.
Follow Lockout Tagout
while attaching or disconnecting hoses or fittings to the machine.
Prior to disconnecting the air supply hose, ensure the air pressure has
been shut off and pressure bled from the hose. The air hose is normally
pressurized while in idle or in operation.
Do not use one wrench when tightening or replacing fittings. Always use
two wrenches to install and remove hoses and accessories.
When attaching the blast hose, make sure to put a 1in wrench on the
base connection of the rotary union. DO NOT rely on the polymer
housing to keep it from rotating. Any connections that are frozen should
be thawed by running air only through the applicator if machine has
been in operation.
section of this manual.
procedures and always shut off the air pressure
20 2023-08-29