PHYWE Cobra4 Manual

PHYWE Cobra4 Manual

Sensor-unit electrophysiology

Advertisement

Quick Links

PHYWE Systeme GmbH & Co. KG
Robert-Bosch-Breite 10
37079 Göttingen
Germany
+49 (0) 551 604-0
Phone
+49 (0) 551 604-107
Fax
E-mail
info@phywe.de
Internet
www.phywe.com
Operating instructions
The unit complies with
the corresponding
EC guidelines
TABLE OF CONTENTS
1

SAFETY PRECAUTIONS

2
3
3.1
3.2
4
5
5.1
5.2
5.3
5.4
6
7
8
9
www.phywe.com, © All rights reserved
Cobra4 Sensor-Unit Electrophysiology
Fig. 1: 12673-00 Cobra4 Sensor-Unit Electrophysiology
1
SAFETY PRECAUTIONS
Attention!
Do not use the Cobra4 Sensor-Unit Electrophysiology
if an attached device is connected to the mains volt-
age!
Read these operating instructions carefully and com-
pletely before putting your Cobra4 Sensor-Unit into op-
eration. Also similarly read the operating instructions for
the Cobra4 measured data recording instrument that is to
be used with the Sensor-Unit for measured value re-
cording. By doing so, you protect yourself and your
equipment.
Only use the Cobra4 Sensor-Unit for the purpose that it is
intended for.
This Cobra4 Sensor-Unit is only to be operated in dry
rooms in which there is no risk of explosion.
Protect the Cobra4 Sensor-Unit from dust, moisture and
vapours. Clean it with a slightly moistened, lint-free cloth.
Aggressive cleaning agents and solvents are unsuitable.
Do not attempt to open the housing of the Cobra4 Sen-
sor-Unit.
Take care that no liquid penetrates through the housing
into the Cobra4 Sensor-Unit, as this would then be dam-
aged.
Only connect the data output of the Cobra4 Sensor-Unit
to measurement recording instruments and measuring
lines that are designed for use with it.
12673-00
1
12673-00 / 2616

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Cobra4 and is the answer not in the manual?

Questions and answers

Summary of Contents for PHYWE Cobra4

  • Page 1 By doing so, you protect yourself and your equipment. Putting into operation  Only use the Cobra4 Sensor-Unit for the purpose that it is intended for.  This Cobra4 Sensor-Unit is only to be operated in dry rooms in which there is no risk of explosion.
  • Page 2 Operation of it is carried out via a hand- carefully through this section. held Cobra4 Mobile-Link 2 or, in the case that it is connected 5.1 Putting into operation to a Cobra4 Wireless/USB-Link, via a computer or mobile de- vice.
  • Page 3 Select the desired type of measurement, ECG, EOG or EMG in Cobra4 measure as follows: Double click on “voltage ” the need for any preparatory measures. When they are to be under the “Electrophysiology”...
  • Page 4 Unplug when in use! Alligator clips for single-use electrodes (3/pack) 12673-02 For safety reasons, the Sensor must only be used if the attached Cobra4 measured data recording instrument is not con- WARRANTY nected to the mains voltage! We guarantee the instrument supplied by us for a period of 24 months within the EU, or for 12 months outside of the EU.

Table of Contents