Cleaning; Maintenance; Storage / Transport; Troubleshooting - saro DA 388 GWS Operating Instructions Manual

CLEANING

Wipe the outside and inside with a damp, soft cloth.
A mild washing-up liquid can be used for this purpose.
Wipe again without cleaning additive, then rub dry well.
Do not use abrasive, bleaching, corrosive or scratching cleaning agents/cleaning aids, as this could damage/scratch the surfaces.
It is recommended to clean the water tank regularly, or when necessary, to avoid contamination of the food.

MAINTENANCE

Check the ventilation slots for dirt. Brush with a soft brush and at the same time vacuum up the dirt with a vacuum cleaner

STORAGE / TRANSPORT

Remove all food, switch off the appliance, unplug the appliance.
Clean the appliance thoroughly inside and out and open the door to allow the appliance to dry sufficiently.
If it is dry and the unit is not to be used for a longer period of time, store it in a dry, dust-free and not hot place. It is best to cover
the unit or use the original packaging to protect the unit from damage.
Secure the unit against children and pets climbing into it, so that they cannot be trapped there.
When storing only the packaging material, please note that components of the packaging such as plastic bags, cardboard,
polystyrene parts, etc., can be dangerous for children if they play with them unsupervised (e.g. choking hazard). can endanger
children if they play with them unsupervised (e.g. choking hazard).
When transporting the unit, it is best to use the original packaging so that the unit is optimally protected against impact, sharp
edges, weather conditions, etc. Do not tilt the unit more than 45 degrees and do not expose it to moisture or rain and avoid
strong vibrations. After transport, the unit must stand for approx. 24 hours without further movement before it can be
reconnected. Otherwise, a defect may occur as the refrigerant and oil must be distributed/placed correctly again.
The appliances can be defrosted manually, but also have an automatic defrost function. The defrost water is collected in a drip
tray. The water in the collection tray evaporates automatically. If the humidity is high, a certain amount of water may collect in
the drip tray. Empty it if necessary.

TROUBLESHOOTING

Problem
No cooling
Unsatisfactory cooling
performance
Strong noises
The unit switches on and off
frequently
The light does not work
Contact your dealer if the problems cannot be solved by simple troubleshooting.
If the door is open for more than 5 minutes, the door alarm system is activated. The LED lights start flashing and an
alarm sounds. Close the door and the LED lights stop flashing and the alarm turns off.
Cause and solution
Is the plug inserted? Is the socket in order? Is the fuse defective? Power failure? Thus
realise the power supply of the appliance again.
Direct sunlight? Is there a heat source nearby? Is the ventilation of the environment poor?
Does the door close properly? Is the door opened for a long time? Is the door sealing strip
deformed or damaged? Is there too much food inside? Is food blocking the air inlet or outlet?
Are the condenser and ventilation slots dust-free and clean?
Remedy this by readjusting the temperature controller.
The unit is not properly levelled.
The unit is touching the wall or other objects. Something is loose on the unit.
Correct the safe, straight stance and/or remove the touches.
The temperature inside is higher than usual. The door is opened too often. Keep the door
closed.
Overload of the appliance? Is the door completely closed?
The circuit breaker has tripped or a fuse has blown. The light is damaged. The light has not
been switched on.
Seite 29 von 32
09/23 SvN