Operation - (Display) Settings; Cleaning - saro GTK 600 PRO Manual

OPERATION - SETTINGS
Digital temperature controller
This is an intelligent controller suitable for a 1 hp compressor. It has a temperature display, temperature control, manual and automatic
defrost function, evaporator fan control, high and low temperature alarms, end of defrost time and temperature setting, value storage,
self-test and parameter lock.
Switch on
- Insert the mains plug into the socket. The appliance switches on.
Operation via the display
When switching on for the first time, press the ▼ key once to deactivate the compressor delay and start the compressor immediately
for cooling.
1. Set temperature:
Press the SET key and the set temperature is displayed.
Press the ▲-key or the ▼-key to change and save the displayed value.
To save the temperature, press the SET button again or wait 6 seconds.
- Switch on/off: Press the
processes are stopped except for the lighting. Press the button again and the measured temperature is displayed. Cooling
mode is started after a short delay time.
- During cooling, the LED indicator (Refrigeration LED) lights up. When the cooling temperature has been reached, the indicator
light goes out.
During the delay process, the display flashes.
- Press the button once to switch the light on or off.
2. Manual defrost:
Press and hold the
During defrosting the LED indicator light is on, after defrosting the LED indicator light flashes while the delay indicator is on.

CLEANING

Wipe the exterior and interior surfaces with a damp, soft cloth. Mild dish soap can be used if necessary. Then, wipe again without any
cleaning additive, and finally, dry thoroughly.
Do not use harsh, bleaching, corrosive, or abrasive cleaning agents/tools, as they may damage or scratch the surfaces.
for 3 seconds to switch off the cooling mode and the temperature display. "---" is displayed and all
button for 6 seconds to start or stop manual defrost. The defrost light comes on.
Seite 23 von 29
07/23 SvN