Connection - saro DA 388 GWS Operating Instructions Manual

The mains cable is 2 m long and is located at the back on the right-hand side when viewed from the front.
After delivery or transport of the unit, connect it only after the unit has been at rest for at least 24 hours.
This is absolutely necessary so that the refrigerant can collect in the compressor. Leave the door open
during this time.

CONNECTION

After prolonged transport, the unit should not be put into operation until 24 hours have elapsed, also after
strong inclination; that the cooling circuit stabilises again, refrigerant distributes evenly again
in order not to cause a defect or malfunction.
After short movement and inclination below 45 degrees, please wait 2 hours before connecting.
Before connecting the unit, make sure that the voltage and frequency of the power supply match the specifications on t h e type
plate! Other voltages can cause the unit to overheat!
Only connect the appliance to an earthed socket outlet with a 230 volt connection.
Once you have connected the appliance, wait about an hour to allow the interior to cool down sufficiently before loading it with
goods.
After a power failure or if the unit has been disconnected from the mains, wait at least 5 minutes before reconnecting the unit
and putting it into operation!
If the unit is restarted immediately after it has been switched off, the fuse may blow and interrupt the flow of electricity. In addition,
the compressor may be overloaded and damaged.
Instructions for removing and inserting the shelf:
Step 1: Remove the shelf:
Look at the drawing below.
Carefully pull one side of the shelf out of the shelf support.
Step 2: Remove the insertion bend
Note the arrow markings on the insertion sheet.
Align the insertion arch opposite the shelf support.
Carefully lower the insertion bend and push it into the receptacle until it is securely engaged.
Now the insertion bend is detached and removed. To put the insertion sheet back in, follow the reverse steps and make sure it
is securely locked in the receptacle.
Seite 24 von 32
09/23 SvN