Connection; Structure And Parts; First Commissioning - saro SB-K 130 Operating Instructions Manual

CONNECTION

After prolonged transport, the unit should not be put into operation until 24 hours have elapsed, also after
strong inclination; that the cooling circuit stabilises again, refrigerant distributes evenly again
in order not to cause a defect, a malfunction.
After short movement and inclination below 45 degrees, please wait 2 hours before connecting.
Before connecting the unit, make sure that the voltage and frequency of the power supply match the specifications on the type
plate! Other voltages can cause the unit to overheat!!!
Only connect the appliance to an earthed socket outlet with a 230 volt connection.
Once you have connected the appliance, wait about an hour to allow the interior to cool down sufficiently before loading it with
goods.
After a power failure or if the unit has been disconnected from the mains, wait at least 5 minutes before reconnecting the unit
and putting it into operation!
If the unit is restarted immediately after it has been switched off, the fuse may blow and interrupt the flow of electricity. In addition,
the compressor may be overloaded and damaged.

STRUCTURE AND PARTS

FIRST COMMISSIONING

Before first use:
Unpack the appliance, check that it is complete and set it up (see Setting up the appliance). Clean the appliance (see Cleaning).
Connect the cleaned cooling unit (see unit connection) to a 230 V socket.
Only when the desired temperature has been reached do you place your goods in the appliance.
Stand 01/23 SvN
Seite 20 von 25