Installation; Connection - saro FKT 935 Operating Instructions Manual

In this case, disconnect the unit from the mains and contact your specialist dealer!
•
Never attempt to open or repair the unit yourself. There is a danger to life!
•
Do not touch the compressor, it could cause burns.
•
Do not drill or pierce a hole in the unit, either from the outside or inside.
Do not install any other appliances on the cooling unit or place any foreign objects there.
•
Do not interfere with the cooling circuit! This is the responsibility of a specialist!
Refrigerants R600a, R290 are very environmentally friendly - but are colourless, almost odourless, flammable gases;
heavier than air; narcotic and suffocating in high concentrations!
•
Repairs must be carried out by appropriate specialists using the original spare parts.
•
Always disconnect the appliance from the mains before cleaning, and also if it is not going to be used for a long time.
• For hygienic reasons, at least daily cleaning is recommended, but also in the course of a day if necessary.

INSTALLATION

Set up the unit in a dry and sufficiently ventilated room. Make sure that the unit is placed on a dry and non-slip surface.
Place the back of the appliance at least 10 cm from the wall to ensure sufficient air circulation at all times. There should be at
least 30 cm above the unit and 10 cm to each side.
Performance and power consumption may be affected by ambient temperature or direct sunlight. Therefore, do not expose the
appliance to direct sunlight and do not place it in the immediate vicinity of a cooker, radiator or other heat source.
Ensure that the mains plug is always freely accessible and can be disconnected from the mains without difficulty.

CONNECTION

After prolonged transport, the unit should not be put into operation until 24 hours have elapsed, also after
strong inclination; that the cooling circuit stabilises again, refrigerant distributes evenly again
in order not to cause a defect, a malfunction.
After short movement and inclination below 45 degrees, please wait 2 hours before connecting.
Before connecting the unit, make sure that the voltage and frequency of the power supply match the specifications on the type
plate! Other voltages can cause the unit to overheat!!!
Only connect the appliance to an earthed socket outlet with a 230 volt connection.
Once you have connected the appliance, wait about an hour to allow the interior to cool down sufficiently before loading it with
goods.
After a power failure or if the unit has been disconnected from the mains, wait at least 5 minutes before reconnecting the unit
and putting it into operation!
If the unit is restarted immediately after it has been switched off, the fuse may blow and interrupt the flow of electricity. In addition,
the compressor may be overloaded and damaged.
Stand 05/23 SvN
After delivery or transport of the unit, connect it only after the unit has been at rest for at least 24 hours.
This is absolutely necessary so that the refrigerant can collect in the compressor.
Seite 19 von 25