Connect To The App; Instructions - Roborock Q80ULL User Manual

Notes:
• Wash the mop cloth after each use, and regularly empty the
water tank of unused water.
• Remove the mop cloth mount when not mopping.

Connect to the App

This robot supports both Roborock and Mi
Home apps. Choose the one that best
meets your needs.
❶ Download app
Option 1: Search for "Roborock" in the App
Store or Google Play or scan the QR code
to download and install the app.
Option 2: Search for "Mi Home" in the App
Store or Google Play or scan the QR code to
download and install the app.
❷ Reset WiFi
Press and hold the and buttons until
you hear the "Resetting WiFi" voice alert.
The reset is complete when the WiFi
indicator light flashes blue slowly. The robot
will then wait for a connection.
Note: If you cannot connect to the robot due to your router
configuration, a forgotten password, or any other reason,
reset the WiFi and add your robot as a new device.
❸ Add device
Open the Roborock App, tap the "Search for
device" button, or open Mi Home app, tap "+"
in the top right corner and add the device as
instructed in the app.
Notes:
• The actual process may vary due to ongoing app updates.
Follow the instructions provided in the app.
• Only 2.4 GHz WiFi is supported.
• If the robot waits more than 30 minutes for a connection,
WiFi will be automatically disabled. If you want to reconnect,
reset the WiFi before proceeding.

Instructions

On/Off
Press and hold the button to turn on the
robot. The power indicator will turn on and
the robot will enter standby mode. Press
and hold the button to turn off the robot
and complete the cleaning cycle.
Note: The robot cannot be turned off when it is being charged.
Starting Cleaning
Press the button to start cleaning. The
robot will plan its cleaning route according
to its scan of the room. It splits a room into
zones, first draws out zone edges, and then
fills the zone in a zigzag pattern. In so
doing, the robot cleans all zones one by
one, efficiently cleaning the house.
08
Zone 1 – Cleaned Zone 2 – Cleaned
Zone 4 – Next Zone Zone 3 – In Progress
Notes:
• To allow the robot to automatically vacuum and return to
the dock, start the robot from the dock. Do not move the
dock during cleaning.
• Cleaning cannot start if the battery level is too low. Allow the
robot to charge before starting the cleanup.
• If cleaning is completed in less than 10 minutes, the area
will be cleaned twice.
• If the battery runs low during the cleaning cycle, the robot
will automatically return to the dock. After charging, the
robot will resume where it left off.
Spot Cleaning
Press the button to start spot cleaning.
Cleaning range: The robot cleans a
1.5 m (5 ft) x 1.5 m (5 ft) square area
centered on itself.
Note: After spot cleaning, the robot will automatically return
to the starting point and enter Standby mode.
Pause
When the robot is running, press any
button to pause it, press the
resume cleaning, and press the
send it back to the dock.
Note: Placing a paused robot on the dock manually will end
the current cleanup.
button to
button to