Project EV APEX-7.3 Instruction Manual page 4

Safety Information
Product Handling
To ensure safety, the following points should be paid attention to:
- All accessories are placed separately during transport or handling.
- Avoid violent shock and impact.
Out of the box inspection
- Please open the charging pile packaging and verify all parts according to the
attachment list.
- Check the charging pile for damage in transport. If damage or missing parts are
found, do not install and inform the carrier and dealer. Determine if this machine is the
model that you want to purchase.
- Note: Please keep the packing boxes and packaging materials for future handling.
Install
- Pre-installation preparation
The following tools are required for the installation:
Screwdriver, spirit level, cable strippers, crimping pliers
- Installation precautions
Please strictly follow the wiring requirements and correct access. Please confirm that all
fasteners are locked to secure the charging pile.
- Installation placement environment and location
- The area where the charger must be placed must be well ventilated, far away from
water, combustible gas and corrosive agent.
- Ensure that the ground or installation platform can withstand the weight of the
charger.
- If the charger is disassembled and used at low temperature, there may be ingress of
moisture, be sure to wait for the charger to be completely dry. After dryness can be
installed and use, otherwise there is a danger of electric shock.
- Please place the charger near the mains input or near an isolation switch to
disconnect and cut off the power supply in an emergency.
Note: The actual installation needs to comply with current wiring regulations and local
safety regulations.
Ensure that the wall or column is vertical or positive 15 ° before installation.
Vertical Front Tilt Back Tilt Flat
4