Remove And Replace The Ssd - Cisco Firepower 9300 Hardware Installation Manual

Hide thumbs Also See for Firepower 9300:

Table of Contents

Remove and Replace the SSD

Step 9

Press the handle so that it catches the edge of the chassis and presses the security module all the way in.

Step 10

Using your fingers, tighten the captive screw on the front of the security module; if using a screw driver, tighten to no

more than 3 in-lbs.

Tightening the captive screws with your fingers is unlikely to lead to stripped or damaged captive screws.

There are two SSDs in each security module. They are configured in a RAID 1 configuration. If one or both

SSDs fail, you must decommission the security module and acknowledge the slot to start the SSD installation

and update the inventory. See the "Security Module/Engine Management" chapter in the

Chassis Manager Configuration Guide

can remove the SSDs, install the new SSDs, and acknowledge the slot to bring the security module back

online.

Note

Once you replace the SSD, the storage controller rebuilds the newly installed SSD and no loss of data should

occur. If both SSDs fail, no data can be recovered.

Note

The two SSDs in RAID 1 store each other's data. Breaking the RAID pair to use in another service module

causes the service module to fail discovery by the Supervisor.

Step 1

Decommission the security module.

Step 2

To remove an SSD, face the front of the chassis, press the handle release on the SSD and gently pull it out of the slot.

Cisco Firepower 9300 Hardware Installation Guide

for the instructions. After you decommission the security module, you

Installation, Maintenance, and Upgrade

Cisco FXOS Firepower

Table of Contents