Install The Fips Opacity Shield - Cisco Firepower 9300 Hardware Installation Manual

Hide thumbs Also See for Firepower 9300:

Table of Contents

Installation, Maintenance, and Upgrade

Install the FIPS Opacity Shield

Caution

This procedure should be performed only by the Crypto Officer. If your Firepower 9300 is already up and

running when you receive the FIPS opacity shield, the Crypto Officer must power it down, remove cables,

attach the FIPS opacity shield, attach the tamper-evident labels (TEL), recable, and power on the Firepower

9300. See the

about the duties of the Crypto Officer.

This procedure describes how to install the FIPS opacity shield on the front of a Firepower 9300 that is already

rack-mounted. The FIPS opacity shield has an access cover that is already attached with two captive screws.

The FIPS opacity shield covers the pullout asset card on the front panel that contains the serial number, but

there is another pullout asset card on the side of the chassis and the serial number is also printed on the top

of the Supervisor. See

chassis. You need the serial number whenever you contact Cisco TAC.

Before you begin

You need the following before you install the FIPS opacity shield:

• Phillips head screwdriver

• Chassis already rack-mounted

• All cabling disconnected from the front of the chassis

• FIPS kit

Step 1

Remove the two screws from each side of the chassis brackets.

The chassis sits on rails that support its weight so it will not fall when the screws are removed.

Step 2

Using the four 10-32 x .75-in. screws from the FIPS kit, attach the FIPS opacity shield to the left and right chassis brackets,

two for each side.

FIPS 140-2 Non Proprietary Security Policy Level 2 Validation

Serial Number Location, on page 8

• Four 10-32 x .75 -in. crews

• FIPS opacity shield

• Twelve tamper-evident labels

document for more information

for the placements of the serial number on the

Cisco Firepower 9300 Hardware Installation Guide

Table of Contents