Cisco Firepower 9300 Hardware Installation Manual page 84

Install the FIPS Opacity Shield
Figure 53: Run the Cables Through the FIPS Opacity Shield
1 Cable exit
Step 6 Attach the TELs. For information on the procedure and correct placement of the TELs, see the Tamper Evidence Label
(TEL) Placement section in the
Step 7 Connect the power cords to the chassis, and plug the other end into your power source. The chassis has a power switch
on the rear. Toggle it to the ON position.
Note The initial AC-power chassis does not have an on/off switch; it powers on when you plug it into a power source.
When you toggle the power switch from ON to OFF, it takes several seconds for the system to power down.
Note
Do not remove the power cable until the power LED is off. After removing power from the chassis either by
moving the power switch to OFF or unplugging the power cord, wait at least 10 seconds before turning power
back ON.
Step 8
Check the SYS LED on the front of the chassis. See
When the SYS LED is solid green, the chassis has booted up successfully.
Step 9
See the Cisco Firepower 9300 Getting Started Guide
Cisco Firepower 9300 Hardware Installation Guide
80
FIPS 140-2 Non Proprietary Security Policy Level 2 Validation
Supervisor, on page 11
for further configuration information.
Installation, Maintenance, and Upgrade
document.
for a description of the SYS LED.