You can press
computer functions may still be operable; however, the battery will not
be charged properly.
MS-DOS Messages
The MS-DOS operating system may display a warning or error message
if it encounters a problem with a command in the CONFIG.SYS or
AUTOEXEC.BAT file, or a command that you entered at the DOS
prompt. Following are a few of the most common MS-DOS messages.
Bad command or file name
Bad command or file name
Bad command or file name
Bad command or file name
Bad command or file name
A command was entered that is spelled incorrectly or does not exist on
the computer.
Invalid media type reading drive D
Invalid media type reading drive D
Invalid media type reading drive D
Invalid media type reading drive D
Invalid media type reading drive D
Abort, R
Abort, R
Abort, Retr
Abort, R
Abort, R
The PC memory card may not be formatted. Press
format the card using the MS-DOS Format command, or from Windows
using the Format Disk command.
Invalid drive specification
Invalid drive specification
Invalid drive specification
Invalid drive specification
Invalid drive specification
You tried to access a drive that does not exist. This can happen if you
try to access drive D, but the PC card drivers are not loaded. Report
this error to your supervisor or your organization's help desk.
Non-System disk or disk error
Non-System disk or disk error
Non-System disk or disk error
Non-System disk or disk error
Non-System disk or disk error
R R R R R eplace and press any k
eplace and press any k
eplace and press any key when ready
eplace and press any k
eplace and press any k
This can occur if a PC memory card is in the card socket and you
restart the computer. Remove the card, then press any key.
Not ready reading drive D
Not ready reading drive D
Not ready reading drive D
Not ready reading drive D
Not ready reading drive D
Abort, R
Abort, R
Abort, Retr
Abort, R
Abort, R
Make sure the PC card is fully inserted into the card socket, then press
to retry.
R
79-0002-002 04/99
to continue to use the computer since basic
ENTER
etr
etry y y y y , F
etr
, F
, F
ail?
ail?
etr
, Fail?
, F
ail?
ail?
ey when ready
ey when ready
ey when ready
ey when ready
etr
etr
etry y y y y , F
, F
, F
ail?
ail?
etr
, Fail?
, F
ail?
ail?
Section 4. Error and Warning Messages
to abort, then
A
35
Need help?
Do you have a question about the X-C 6250 Pro and is the answer not in the manual?
Questions and answers