Decommissioning And Treatment At End Of Life - ABB SACE Emax 2 Series Operating Instructions Manual

Decommissioning and treatment at end of life

1 - Decommissioning and treatment at end of life
Safety standards During the early stages of the process of decommissioning and end of life treatment of SACE Emax 2
Trained personnel The operations for decommissioning SACE Emax 2 circuit-breakers involve performing procedures that
End of life treatment for
circuit-breaker materials
Disposal of packing materials The materials used for the packaging of SACE Emax 2 circuit-breakers are recyclable and should be treated
296 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
circuit-breakers, observe the following safety rules:
• the closing springs, even if discharged, must never to be taken apart.
• instructions for handling and lifting the circuit-breakers are given in the "Unpacking and handling"
1SDH000999r0002
chapter of document
E4.2 and E6.2.
HAZARD! RISK OF ELECTRIC SHOCK! Unplug or disconnect any power supply, to avoid
any potential risk of shock during removal of the circuit-breaker from the service.
WARNING! After dismantling the switchgear, the circuit-breaker must be stored in the
open position with the closing springs discharged and with the front cover mounted.
can be performed by Trained Persons in the electrical field (IEV 195-04-02: person adequately advised or
supervised by electrically skilled persons to enable him or her to perceive risks and to avoid danger which
electricity can create).
The materials used in the production of SACE Emax 2 circuit-breakers are recyclable and should be treated
separately as shown in the following table:
TYPE MATERIAL
A Plastic parts
B Metal parts
C Printed circuits
D Current sensors, cables, motors, electrical windings
All the components of significant dimensions bear a mark specifying the type of material.
(1)
NOTE: refer to the national legislation in force at the time of decommissioning of the product,
in the case where it specifies end of life treatment procedures different from those indicated.
separately as shown in the following table:
TYPE MATERIAL
A Plastic parts
B Cardboard parts
C Wooden parts
D Metal parts
NOTE: refer to the national legislation in force at the time of decommissioning of the product,
if it provides for disposal procedures other than those specified.
for E1.2 or in the document
(1)
Decommissioning and treatment at end of life
1 - Decommissioning and treatment at end of life
ABB | SACE Emax 2
1SDH001000r0002
for E2.2,