Additional Settings - ABB SACE Emax 2 Series Operating Instructions Manual

2 - Additional settings

Presentation Via the service connector (via Ekip Connect) or system bus communication, you can:
Programmable States There are sixteen independent programmable states identified by the letters A, B, C, D, E, F, G, H, I, L, M, N,
Filters Measuring filters can be activated on channels S.G.R., MDGF, Rc and V0:
TAG Name, User data Tags that can be programmed by the user to facilitate remote identification of units.
134 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
A description of the different functions is given below.
O, P, Q, R, offering different solutions for event control.
Each programmable status can have two values: True or False. There are also various configuration
parameters available:
• Trigger , event or combination of several status activation events (up to 24, in AND or OR logic
configuration)
• On Delay : status activation delay calculated from trigger presence onwards
• Off Delay : status de-activation delay calculated from trigger absence onwards
NOTE: the status activates if the trigger is present for longer than the On delay setting and
de-activates if the trigger is absent for longer than the Off delay setting
Figure 33
The statuses can be used with external module Ekip Signalling 10K , on Link Bus or with the programmable
functions, so as to convey the required signaling combination to the contacts.
• GTE filter : available if the external toroid is present (S.G.R., MDGF or Rc).
• V0 filter available with neutral connection activated
If the filter is activated, the measurements and specific protections (Gext, MDGF or Rc for GTE filter,
and V0 for V0 filter) are dealt with differently: Ekip Touch applies a pass-band filter to the signal so as to
measure the fundamental component only (50 or 60 Hz).
NOTE: the Name TAG and communication address form the identification used by Ekip
Connect for the connected devices
ABB | SACE Emax 2
Ekip Touch - Settings
2 - Additional settings