Console Setup - Amcrest AMDV5M32-6TB Quick Start Manual

The DVR has connections for only 1 hard drive inside the case and the hard drive must be
no bigger than 10TB (Terabytes).
To install your hard drive, the following is needed:
A medium sized (regular) Phillips-head screwdriver - not included
A hard drive - not included (unless you purchased a 'kit' that does have one included)
Four hard drive fastening screws - included
Note: Before installing the hard drive, make sure the DVR is powered off and completely
disconnected from power.
1. Loosen the screws on
the upper cover and side
panel.
4. Turn the device over
secure the screws.
Once the hard drive is installed, turn on the DVR. If the hard drive for your DVR was not setup
properly you may hear a beeping noise. This indicates the DVR does not have the proper
connection with your hard drive.

Console Setup

Device Initialization
After turning the system on, the default video display will show multiple windows and a device
initialization page will appear. Follow the on-screen prompts to complete initialization.
Password Setting
The first thing you will need to do in the setup process is create a new admin password for your
device. The password for your device should be between 8 and 32 characters with a combination
of letters, numbers, and symbols are recommended.
Note: Please do not use special symbols like ' " ; : &
Once you have entered a new password for your device, confirm the password in the next field.
2. Attach four screws in the
HDD (Turn three times.)
5. Connect the HDD data cable
and power cable to the HDD.
3. Place the HDD in accordance
with the four holes on the bottom.
6. Attach the cover onto the DVR
and secure it using the screws.
6