Table of Contents
Advertisement
HDD
abnormal
HDD
indication
light
IR Receiver
2. Rear Panel
Please refer to the following chart for detailed information on the rear panel ports:
#
Name
1
Video input
4
Audio input
7
USB port
10
Power socket
3. Hardware Setup
Before setting up the HDCVI, you will probably need the following items. The items are not
included:
A computer monitor or TV with either an HDMI or VGA input
A power strip with room for 4 large power plugs
Note: It is recommended to connect all components of the system as shown below BEFORE
mounting any of the cameras. This is to ensure all components are working. If any components
are not functioning, please contact Amcrest Support.
To set up the DVR hardware, there are 7 major steps:
1. Connecting a monitor to the DVR. The DVR is compatible with any monitor that uses a
VGA or HDMI connection. For purposes of this guide, we will use a VGA connection.
When an HDD error occurs or the HDD capacity is below the
specified threshold, this LED becomes red to alert you.
This is used to receive the signal from the remote control.
#
Name
2
Video output
5
Video VGA output
8
Network port
11
On/Off button
#
Name
3
Audio output
6
HDMI port
9
RS-485 input port
12
GND port
4
Advertisement
Table of Contents
