Transport Of Cones - probst SRG-UNI-3-K Operating Instructions Manual

Operating
Lead the device (SRG-UNI) only at the handles of the claws.
•
Unlock all the holdfast applications (1) and rotate downwards: the angle levers (5) are rotated downwards by
means of the springs.
•
Both clamping jaws (6 and 7) must have contact with the complete surface of the manhole (Fig. 2). Lift manhole
by approx. 10 cm.
Do not load the jaws by pulling to one side and
do not drag jaws along the ground (Fig. 4).
Distortion and danger of the releasing the load!
Do not swing the load and do not allow people
to remain underneath load: Danger of releasing
the load!
After controlling the tight and safe fit of the jaws
onto the manhole (Fig. 1) the manhole should be
transported closed to the ground, otherwise there
is a danger of the load being released!
After setting down of the manhole and the releasing of the tie rods, block all holdfast applications. Now the claws can
be lifted by means of a lifting device (e.g. crane).
(SRG-uni)
The device can now be lifted with the lifting device and transported carefully to the place of destination.
5.2

Transport of cones

The adjustment and the control for the transport of cones are carried out the same way as with the manholes.
Furthermore, however, the following must be respected:
The transport of symmetrical cones is carried out as follows:
•
Equally position jaws onto the manhole.
•
When the jaws are safely positioned onto the cone, slowly lift cone.
As far as asymmetrical cones are concerned it is preferably worked with 2 claws (respect carrying capacity!):
Place one claw at the vertical side and the other one symmetrically opposite on the sloping face of the cone. Now the
cone can be carefully lifted
54400019 12 / 18
Fig. 4
GB