Table of Contents
Advertisement
r Connecting terminals
1
<AUDIO IN> terminal
This is a terminal to input audio signal.
2
<AUDIO OUT> terminal
This is a terminal to output the audio signal input to the projector.
3
<COMPUTER IN> terminal
This is a terminal to input the RGB signal or YC
4
<MONITOR OUT> terminal
This terminal can output the RGB signal or YC
input from the <COMPUTER IN> terminal to an external device.
5
<HDMI IN 1> terminal/<HDMI IN 2> terminal
This is a terminal to input the HDMI signal.
6
<SERIAL IN> terminal
This is the RS-232C compatible terminal to externally control the
projector by connecting a computer.
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
f To transmit the Ethernet and serial control signals using the <DIGITAL LINK/LAN> terminal, set the [NETWORK] menu → [ETHERNET
TYPE] to [DIGITAL LINK] or [LAN & DIGITAL LINK].
f To transmit the Ethernet signal using the <LAN> terminal, set the [NETWORK] menu → [ETHERNET TYPE] to [LAN] or [LAN & DIGITAL
LINK].
f The <DIGITAL LINK/LAN> terminal and the <LAN> terminal are connected inside of the projector when the [NETWORK] menu → [ETHERNET
TYPE] is set to [LAN & DIGITAL LINK]. Do not directly connect the <DIGITAL LINK/LAN> terminal and the <LAN> terminal using LAN cable.
Construct the system so that it is not connected to the same network via the peripherals such as the switching hub or the twisted-pair-cable
transmitter.
f When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [NORMAL], the <USB (DC OUT)>
terminal can supply power even in standby state. If set to [ECO], the <USB (DC OUT)> terminal can not supply power in standby state.
f When an external device exceeding the rating (DC 5 V, maximum 2 A) is connected to the <USB (DC OUT)> terminal, an error is detected
and the power supply will be stopped. At this time, disconnect the external device, cut off the power of the projector and then reconnect the
power plug to the outlet.
30 - ENGLISH
Chapter 1 Preparation — About your projector
1 2
3
4
5
C
/YP
P
signal.
B
R
B
R
C
/YP
P
signal
B
R
B
R
6
7
8
7
<USB (DC OUT)> terminal
This is a terminal to connect the USB memory when using the
data cloning function or firmware update function. ( x pages 179,
185)
This is also the terminal to connect the optional Wireless Module
(Model No.: AJ-WM50 Series) when the projector is connected
via wireless LAN. ( x page 151)
This terminal is also used for power supply.
(DC 5 V, maximum 2 A)
8
<DIGITAL LINK/LAN> terminal
This is a terminal to connect a device that transmits image signal
or audio signal via the LAN terminal. Also, this is the LAN terminal
to connect to the network.
9
<LAN> terminal
This is the LAN terminal to connect to the network.
9
Advertisement
Table of Contents
