Classic Exhibits SEGUE DESIGNS Supernova MOD-1601 Setup Instructions

© 2024
Order #XXXXX
Item Qty. Description
1,1A 1,1 36" CEI152 Vertical Extrusion
2,2A 1,1 36" CEI152 Vertical Extrusion
3,3A 1,1 24" CEI152 Horizontal Extrusion
4,4A 2 Base Plate
-- 1 9" U-Channel
Steps:
1) Attach u-channel to horizontal [3].
See U-Channel Connection detail.
2) Assemble CEI152 extrusions together, flat on floor.
See CEI152 Frame Assembly sheet for instruction.
3) Attach base plates to [3], using bolts, washers, and
wing nuts then lift assembled frame upright.
4) Connect lighting cords and attach transformer then
set transformer into u-channel. See Light to Light
Connection & Light to Transformer Connection
5) Install SEG graphics to front and back of assembled frame.
See SEG Graphic Installation sheet for instruction.
*
U-Channel Attachment
Slide V4 connectors into top groove of horizontal
extrusion. Tighten set-screws to secure. Attach
U-Channel to connectors, using bolts.
Note: V4 connectors stay attached when packing.
MOD-1601 Supernova
3A
1A
details.
1
Transformer
U-Channel
3
4
2A
2
4
SETUP INSTRUCTIONS
If you would like to tell us about your experience with your setup instructions please email us at info@classicexhibits.com
Completed Assembly
Light to Light Connection
Female Male
+
+
Lights
-
-
Light to Transformer Connection
Female Male
+
-
to power
Transformer
144W / 6A / 24V
Maximum of 11 light bars per transformer.