Classic Exhibits visionary DESIGNS MOD-1355 Instructions

MOD-1355 - iPad Kiosk
Hex
Nuts
Steps:
1) Slide infill between stand verticals as shown.
2) Attach horizontal [2] between stand verticals.
3) Attach base [1] to stand verticals using bolts.
4) Attach square plates [3] to stand using bolt.
5) Attach clamshells [4] to square plates [3] using hex nuts.
6) Insert iPads and feed wires through hole.
7) Attach pamphlet trays to stand. Refer to detail.
Adjustable Pamphlet Tray Attachment
*
Tighten Lock
to Secure
Attach connector piece to tray
as shown. Then connect
assembled pamphlet
tray to vertical extrusion.
w w w . c l a s s i c e x h i b i t s . c o m
4
3
Clamshell
Square
Square
Plate
Plate
*
Infill
*
Stand
2
1
WHEN DISASSEMBLING, TIGHTEN ALL SCREWS AND NUTS TO PREVENT LOSS DURING SHIPPING.
Hex
Nuts
Lock
iPad
Optional Cover for Home Button
Foam Lining
Removed
1) Remove foam lining from inside bottom of
clamshell as shown.
2) Attach Home Button Shield with double-sided
tape to inside of clamshell, keeping top of
shield flush with clamshell opening as shown.
Base
NOTE: This is a permanent fix and can't be easily
Plate removed.
Lock
Wire
Access
Home Button Shield
Tools Required:
1) Hex Tool
2) Pliers
866.652.2100
When assembled
Side View
© 2013