Classic Exhibits visionary DESIGNS MOD-1229 Setup Instructions

© 2023
Order #XXXXX
Item Qty. Description
17 1 37.5"h Q914 Vertical Extrusion
18 1 37.5"h Q914 Vertical Extrusion
19 1 37.5"h Q914 Vertical Extrusion w/Door Hinges
20 1 37.5"h Q914 Vertical Extrusion w/Door Stop
21 1 32.5"h Q914 Vertical Extrusion
22 1 32.5"h Q914 Vertical Extrusion
23 5 13.5"w Z45 Horizontal Extrusion
24/24A 2/2 14.5"w Z45 Horizontal Extrusion
25 2 5.75"w Z45 Horizontal Extrusion
25A 2 7"w Z45 Horizontal Extrusion
-- 1 PR63 Conduit
23
21
22
Top
Insert
23
19
24A
24A
*
Infill
Door
23
Infill
Internal
Shelf
*
23
Infill
20
24
17 24
Internal
23
Shelf
18
Supports
MOD-1229 Monitor Stand
Steps:
1) Attach upper Vertical Extrusions [21,22] to lower Vertical Extrusions [19,20].
2) Attach Horizontal Extrusions [23,24 and 24A] between Vertical Extrusions,
placing Infills and attaching
3) Attach Shelf Supports to inside of assembled base using Velcro,
then set Internal Shelf on top of supports.
4) Attach [25,25A] to Verticals [17,18,19,20], then attach Shelves
to Velcro on top of [25,25A].
5) Place Counter Top on assembled base and secure with pins.
See Counter Top Attachment
6) Attach Monitor Mount to assembled workstation where indicated.
See Monitor Mount Attachment
7) Run cords through grommet in counter top & attach PR63 to
vertical [22] as shown for wire management. See
*
Monitor Mount Attachment
*
Align hole with pin
Connectors
Connectors
STEP 1
Slide Connectors into groove of
extrusion. Tighten Set Screws to *
secure.
Slide pin into
hinge attached
to vertical.
Slide door
hinge over pin.
Screws
Monitor
Plate
STEP 2
Attach Monitor Plate to Connectors,
using supplied bolts.
Door where indicated.
detail.
detail.
PR63 Attachment detail.
Counter Top Attachment
1 2
Rotate pin. Spring
will push pin into hole.
Shelf
Door Attachment
25
Door
Hinge
25A
Pin
Hinge
SETUP INSTRUCTIONS
If you would like to tell us about your experience with your setup instructions please email us at info@classicexhibits.com
Completed Assembly
*
*
Grommet
PR63
Counter Top
*
*
Shelf
25A
Velcro
*
PR63 Attachment
pinch
25
1) Run cords through
PR63 plastic conduit.
2) Attach conduit where
indicated by pinching
the opening and
inserting into the
groove of extrusion.