Classic Exhibits visionary DESIGNS MOD-1298 Manual

© 2016
Item Quantity Description
12 1 38" RR91 Vertical Extrusion
13 1 38" RR91 Vertical Extrusion w/Door Stop
14 1 43" RR91 Vertical Extrusion
14A 1 Plate for Counter Connection
15 1 38" RR91 Vertical Extrusion w/Door Hinges
16 2 20" Z46 Horizontal Extrusion
17 2 8.5" Z46 Horizontal Extrusion
18 2 20" Z45 Horizontal Extrusion
19 2 8.5" Z45 Horizontal Extrusion
4 Internal Shelf Support
13
12
14
17
16
16
Stopper at 4"
Extrusions 10 and 11
have a lip for the
floor to rest
upon.
w w w . c l a s s i c e x h i b i t s . c o m
Order #XXXXX - MOD-1298 Pedestal Assembly
Steps:
1) Connect horizontals [16 & 17] between verticals resting on top of stoppers
at approximately 4" up from floor to bottom of metal.
2) Set floor in place on top of lip of horizontal extrusions.
3) Place infills in place as shown.
4) Connect horizontals [18 & 19] between verticals and atop inserts as shown.
5) Velcro shelf supports to inside of pedestal, then set internal shelf atop supports.
6) Hang door on hinges as shown in detail.
7) Place large counter top on top of assembled base.
8) Attach connector plate [14A] to vertical [14] then connect smaller counter to [14A].
9) Attach graphic to front of pedestal with standoffs as shown in detail.
19
Infill
18
15
Infill
Shelf
Support
17
Counter
Top
18
19
Infill
14A
Floor
Counter Top
Slide connector on back of
standoff barrels into groove
of extrusion and twist to
secure in place. Secure graphic
to standoffs using screw caps.
Door
Door Attachment
Slide pin into
hinge attached to
Round Vertical.
Slide Door hinge
atop pin.
Graphic Attachment
Graphic
Standoff
Barrel
Cap
Door
Hinge
Pin
Hinge