Classic Exhibits VISIONARY DESIGNS MOD-1345 Setup Instructions

© 2023
Order #XXXXX

Steps:

1) Attach base plate to straight end of post, using bolt.
2) Attach mounting plate to curved end of post, using bolt.
NOTE: Plate must rotate to left and right before installing clamshell.
3) Attach clamshell to mounting plate, using acorn nuts.
See

Clamshell Attachment

detail.
4) Insert iPad in clamshell, then route cords through holes. See

Cord Management for iPad

detail.
5) Attach graphics to post using A10 clamps. See
Clamshell Attachment
Cord Management For iPad
Lock
Lock
Clamshell
iPad
Attach iPad cord to supplied USB extension
Cord
Access
cord. Feed USB cord through top hole of
post, then out bottom hole of post.
connect to power.
MOD-1336 iPad Kiosk
Acorn
Nut

A10 Clamp

detail.
Cord from iPad
Graphic
Base
Plate
Clamshell
Mounting
Plate
Post
Graphic
USB Extension Cord
SETUP INSTRUCTIONS
If you would like to tell us about your experience with your setup instructions please email us at info@classicexhibits.com
Rotate clamshell
to turn iPad from portrait
to landscape orientation.
A10 Clamp
Connector
1) Slide connector of clamp
into extrusion groove.
2) Tighten set screw when
A10 is in desired location.
3) Insert graphic into clamp.
4) Tighten knob on clamp
Optional Cover for Home Button
to secure graphic in place.
Set Screw
A10 Clamp
Knob
Foam Lining
Removed
1) Remove foam lining from inside bottom of
clamshell.
2) Attach Home Button Shield with double-sided
tape to inside of clamshell, keeping top of
shield flush with clamshell opening.
NOTE: This is a permanent fix and can't be
easily removed.

Completed Assembly

Home Button Shield