Classic Exhibits VISIONARY DESIGNS MOD-1372 Setup Instructions

© 2019
Order #XXXXX
Steps:
1) Install Base Plate to bottom of Kiosk, using bolts.
2) Attach Sintra Graphic to Kiosk, using screw caps.
3) Connect Shelf, using bolts from back side of Kiosk.
4) Attach iPad clamshell to top of Kiosk, as shown in detail.
5) Connect power cords to RGB LED lights on sides of Kiosk.
See opposite page for RGB Remote Controller instructions.
hole for wire
management
screw
caps
Kiosk
Graphic
screw
caps
screw
caps
Base
Plate
bolt
MOD-1372 iPad Kiosk
*
iPad Clamshell Attachment
1) Attach Connector Plate & Spacer to top of kiosk
using bolt to t-nut connection.
connector
bolt
plate
spacer
T-nut
2) Connect iPad clamshell to connector plate with hex nuts.
*** Connector Plate & Spacer stay attached to Kiosk. ***
iPad
Clamshell
connector
plate
spacer
*
bolts
Shelf
*

RGB LED Power Cord Attachment

Clamshell
Connect transformer to RGB LED Controller.
Then connect transformer to power source.
hex
nuts
LED Controller
LED Lights
Clamshell
* *
Transformer
BACK VIEW
SETUP INSTRUCTIONS
If you would like to tell us about your experience with your setup instructions please email us at info@classicexhibits.com
Transformer
FRONT VIEW
Completed Assembly
Cord Management for iPad
Lock
Lock
iPad
Cord
Access
Optional Cover for Home Button
Door
Hole for wire
management
Foam Lining Home Button Shield
Removed
1) Remove foam lining from inside bottom of clamshell.
2) Attach Home Button Shield with double-sided tape to
inside of clamshell, keeping top of shield flush with
clamshell opening.
NOTE: This is a permanent fix and can't be easily removed.
BACK VIEW
Feed iPad cord through
top hole of post, then
out bottom hole of post.
Connect to power.