Classic Exhibits VISIONARY DESIGNS MOD-1538 Setup Instructions

© 2016
Item Qty. Description
1/1A 1/1 47.75"h Vertical Extrusion
2/2A 1/1 47.75"h Vertical Extrusion
3 1 19.917"w Z45 Horizontal Extrusion
-- 1 Large Round Base
1
2
w w w . c l a s s i c e x h i b i t s . c o m
Order #XXXXX - MOD-1538 Assembly
*
Q914 Connector
Connector
Piece
Silde extrusion over
connector and rest on
lower vertical;
secure with screws.
**To prevent product loss,
Keep all screws attached
to connector piece after
disassembling
*
Wire Management
Steps:
1) Run cords through plastic
conduit.
2) Attach conduit where
indicated by pinching the
opening and inserting
into the groove.
3) Attach graphics.
Velcro: For
3
Header Graphic
1A
2A
*
*
SETUP INSTRUCTIONS
If you would like to tell us about your experience with your setup instructions please email us at info@classicexhibits.com
Steps:
1) Slide verticals [1] & [2] into the square holes in top of base.
2) Connect verticals [1A] & [2A] to installed verticals [1] & [2].
See Q914 Connection detail.
3) Attach horizontal [3] between verticals [1A] & [2A].
4) Install Monitor Mount to verticals.
See Monitor Mount Attachment detail.
5) Attach Header Graphic to Velcro installed on verticals.
*
Monitor Mount
Attachment
*
Setscrew
Slide connectors into
groove of extrusion;
tighten setscrew to secure.
Then attach wall plate
to connectors using
supplied bolts.
*