Classic Exhibits VISIONARY DESIGNS MOD-1353 Setup Instructions

© 2023
Order #XXXXX
Item Qty. Description
1 1 Base Plate
2 1 10" Z72 Horizontal Extrusion
3 1 Mount Plate
Literature Clamshell
Holder
*
Literature
*
Holder
In fil l
2
1
MOD-1353 iPad Kiosk
Steps:
1) Slide Infill into stand verticals as shown.
2) Attach horizontal [2] between stand verticals.
3) Attach base plate [1] to stand verticals, using bolts.
4) Attach mount plate [3] to stand, using bolt
NOTE: Mount Plate must rotate to left and right before installing Clamshell.
5) Attach clamshell to mount plate [3], using hex nuts.
6) Insert iPad into clamshell then route cords. See
Hex
7) Attach literature holders to stand. See
Nuts
3
Cord Management
Cord
pinch
Stand
Route cord through conduit.
Attach conduit by pinching
the opening and inserting
into the groove of stand.
*
Literature Holder Attachment
Attach angled end of connector to
literature holder. Attach flat end of
connector to post. Tighten
locks to secure.
Cord Management for iPad
Literature Holder Attachment
Optional Cover for Home Button
Foam Lining Home Button Shield
Removed
1) Remove foam lining from inside bottom of
clamshell.
2) Attach Home Button Shield with double-sided
tape to inside of clamshell, keeping top of
shield flush with clamshell opening.
NOTE: This is a permanent fix and can't be
easily removed.
Lock
Literature
Holder
Connector
Clamshell
Locks
iPad
SETUP INSTRUCTIONS
If you would like to tell us about your experience with your setup instructions please email us at info@classicexhibits.com
detail.
detail.
Completed Assembly
Cord Management for iPad
Lock
Attach iPad cord to supplied USB extension
Cord
Access
cord. Feed USB cord through top hole of
post, then out bottom hole of post.
connect to power.
Rotate clamshell
to turn iPad from portrait
to landscape orientation.